This is interpreting a single number as an IPv4 address. So, like in decimal, we use two digits: 010 = 8. After 07 is the number written as 8 in decimal (base 10), but there aren't any digits left. This uses the digits 0, 1, 2, 3, 4, 5, 6 and 7. This means "treat this number as octal" which is base-8. As well as MVS_TK4-_v1.00_Users_Manual.pdf, with information on username (for instance "HERC01") and password (for instance "CUL8TR"(belonging to HERC01)).Ġ10 has a preceding 0. I found this video Mainframe operating system MVS 3.8 turnkey TK4 how to install and operate helpfull. However I am glad it does work the other way. The TK4 version didn't seem to work on os x and is probably preconfigured for Linux and not os x. Obviously this is not solving how to use any version of IBM System/360 etc. Then I could fill in username and password. Then in another tab of the same terminal c3270 localhost:3270 In the linux vagrantbox I extracted the zipfile to the folder tk4. And I installed with sudo apt install c3270 the telnet terminal emulator in the linux vagrantbox. I downloaded from The MVS 3.8j Tur(n)key 4- System the zip-file tk4-_v1.00_current.zip. On mac os x I have installed Vagrant ,and a vagrantbox for linux 14.04lts. Type 'show copyright' for full copyright information.Ĭonnect to 010, port 3270: No route to hostĪnd what is the meaning of ?: This is the OS master console. This gives an error: $ c3270 -port 3270 -model 3279-2 010Ĭopyright 1989-2014 by Paul Mattes, GTRC and others. Hostname with 010 (since in the second instruction in the 00README.txt file it says device 010.) model 32xx-x with 3279-2 (this seems not so important ?, just about terminal screen size) I assume this works the same for the console version c3270 I installed, thus: Linux: x3270 -port nnnn -model 32xx-x hostname Start an x3270 session and connect to Hercules with the following The first instruction gives me no trouble.Ĭoncerning the second instruction, I found at this site the workings of the 3270 terminal: Telnet/tn3270 Console How-To for Hercules Version 4 , It must be definedĪnd connected at IPL, or the IPL will hang. Using a 3270 emulator, start a telnet session to port 3270 forĭevice 010. From the asp directory, start Hercules:Ģ. Than I did the following instructed in the 00README.txt file: Startup:ġ. Through this site: Running the IBM OS/360 MVT operating system on Hercules ,I followed the instructions and have downloaded the Hercules-ready MVT 21.8 images. With macports I have installed Hercules and c3270. I would like to get working with IBM System/360 on the Hercules emulator.
0 kommentar(er)
